1. The equipment is too heavy, and the selected model of the shock absorber is too small. Solution: provide accurate equipment weight and reselect the model;

2. The valve core is loose, and the shock absorber leaks when the air pump or pump is removed; Solution: Tighten the valve core. If you don't know how to operate it, you can send a small valve wrench and tell how to tighten it.

3. The selection of shock absorbers is too large, and the pressure of the air pump or pump used is too low. Solution: It is recommended to replace the air pump before inflating the shock absorber;

4. Ask the customer to check the position of the valve gasket, the screw position on the top of the shock absorber, the welding joint position, etc. for air leakage (the detection method can be tested with soapy water). Treatment: If there is air leakage, unscrew the valve and wrap it with adhesive tape. If it is indeed found to be air leakage, replace the shock absorber.

5. Improper connection of inflation port, informed that if the connection is good, the connecting tube needs to be supported

6. If the machine foot is biased towards the shock absorber, depending on the type of equipment, and 52 models are selected, the equipment foot can be placed in the center of the shock absorber. Place a link plate above the shock absorber to expand the upper area.

7. Check if the top of the airbag leaks due to excessive inflation caused by the customer

8. Did inflation under no-load cause damage to the shock absorber? If the airbag is damaged, the shock absorber can only be replaced.